Diamond Snap-Form insulated concrete forming system

The Diamond Snap-Form System, incorporating AFM's Diamond Snap-Tie TM and Perform Guard® Insect Resistant* Expanded Polystyrene (EPS), is an efficient, cost-effective insulated concrete forming system. For use either above or below grade in any type of construction, the system combines the insulating effectiveness of EPS with the structural integrity of concrete resulting in a strong monolithic design.

R-20 Wall**

The Diamond Snap-Form System uses 1'x 8' panels of Perform Guard EPS connected by a Diamond Snap-Tie every 12 inches, both horizontally and vertically. The Diamond Snap-Tie creates a cavity for the concrete with two faces of 2" Perform Guard EPS to achieve a nominal R-Value of 20** for the wall system.

*Tested Against Termites and Carpenter Ants. Manufacturer has list of specific species on file. Patent No.5,194,323 and No.5,270,108.
**R-Value at 40 F.

The Diamond Snap-Form System remains in place after the concrete is poured, serving as a wall, insulation, and facing material. Floor and roof assemblies are connected to the wall as with any poured concrete wall.

Factory Corners

The Diamond Snap-Form System utilizes an industry-leading, "pre-formed factory cut" corner. This allows for exact placement of the Diamond Snap-Ties and begins the form building process for maximum installation speed. 90' and 45' corners can be provided as standard.

The Diamond Snap-Form System can be used to create almost any type of wall, including:

Diamond Snap-Tie
  • Diamond-shaped bearing plate stabilizes the form, finishes attach easily.
  • Radius edges for smooth insertion into Perform Guard®. Symmetrical design-no top or bottom.
  • Cradles hold and position rebar up to #6 size.
  • Bearing plate and tension web maximizes tie spacing less ties to install.
  • Plates with tension webs allow for "stacked joint" design of Perform Guard EPS form board - faster installation.

Diamond Snap-Form Advantages

Structures built with the Diamond Snap-Form System are completed quickly and cost effectively. Additionally, the Diamond Snap-Form System offers these benefits:

AFM products are produced exclusively by Partner Plants in AFM Corporation. AFM, Diamond Snap Form, Diamond Snap-Tie and Perform Guard are trademarks of AFM Corporation. © 1995 AFM Corporation